The sander can be used for nail care, repair, base treatment, gel repair/removal, and finishing.
Operation method
1. Nail care
After soaking in water to soften the dead skin, use the special dead skin pusher for the sander to retract from both sides of the nail. Pay attention to control the appropriate force to push up the horny under the dead skin;
Remove the dust on the surface of the nail gully on both sides of the nail scraps in the fingertips;
After subtracting the dead skin, choose a grinding head suitable for the area of the finger skin to grind the hardened keratin around the nail;
Choose a grinding head suitable for the nail condition to smooth the nail surface;
After the nail surface becomes smooth, throw out the gloss in the order of black, white and gray;
2. Repair
After finishing the nail shape with nail rub, use the corners of the diamond grinding head (French) to grind the new smile line groove; put the grinding head against the crystal/gel, and adjust the thickness of the construction part to the thicker gel at the rear edge After grinding, use a steel pusher to push up the dead skin and keratin, etc., choose the most suitable grinding head for the skin and nails to clean and remove the residual keratin under the dead skin.
After patching up the repair gel mixture, use 150G nail rub to shape, and use the curvature of the grinding head to evenly polish the thickness of the nail after extension;
Turn the nail over. In order to make the thickness even with the front end of the extension nail, use a finer tip to grind the height difference;
In order not to damage the skin, use a round tip to remove dead skin on the edge of the finger and correct the overall shape
After rubbing the surface with bubbles until it is smooth, use a deerskin polishing head to polish the surface of the nail to be smoother
3.base treatment
Exfoliate dead skin near the finger edge, remove fine parts of dead skin and barbs, etc.
4.gel repair/removal
Used to polish the curled part of the rear edge and polish the nail surface
5.final modification
When the gel is applied to the back, it can be eliminated by a grinding head, and the hardened gel applied around the finger edge can be removed