Manicure pretreatment skills

- Oct 30, 2020-

Polishing: Generally, you will use a sponge to rub the rough noodles and toss, and then use the fine noodles briefly. This action must be done, otherwise there will be a lot of small raised particles on the nail surface after the color. It is recommended to use less rubbing and try to avoid Damage this armor.


Carving: If you use a softener to repair dead skin, you can save time without soaking in water. Carving should be in place, especially on the root and tip of the nail.


Polishing: When manicuring the nails, go in one direction. Do not polish back and forth. The nails are easy to split and chip. The thick surface of the file is generally used for short nails, and the smooth surface for the final trimming. When removing dead skin, soak it in warm water or use CPMA's wet cutting method. If you cut the dead skin directly, it is easy to cut.


Cleaning: After the nails are polished, use a brush to carefully clean the nail surface, and then use a cleaning fluid or 95° alcohol to wipe both sides of the finger edge and the inner finger core of the fingertip, because these locations are not clean with a brush. , There is a balance liquid that must be used before the primer is applied, which has the effect of removing water and oil, and will be more firm!)


Pre-processing sequence: you can finish the armor type and push the dead skin and start sanding, because after cutting the dead skin and then sanding, there will be fluffy edges around, so it is generally the first to sand and then cut the dead skin, but when cutting the dead skin We need to use the wet shear method!